Kenwood DPC-341 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
What seems to be a serious trouble may sometimes be due to simple mistake. Before calling
for service, check the items shown in the following table again. (If you request servicing due to
the reasons shown In the table, the service may be charged in some cases.)
Symptom
Cause
Remedy
No operation occurs when
operation keysare pressed.
• The HOLD/nESUME switch of the main
unit or remote controller is set to
"HOLD".
• The batteries are exhausted.
• The disc IS placed upside down,
• Condensation occurred inside the unit
• The AC adapter is unplugged.
• Set the switch to other position than
"HOLD".
• Replace both of the two dry cell
batteries, or recharge the recharge
able batteries.
• Place the disc with the labeled side
up.
• Leave the unit for about 1 hour
before re-use.
• Connect properly.
No sound is heard from the
headphones.
• The headphones are connected incom
pletely.
• The volume is set to the minimum posi
tion on the main unit or remote control
ler.
• Insert the plug securely into the
PHONES jack.
• Adjust the volume on the main unit
or remote controller.
Sound skips, or is inter
rupted.
• The system is located subject to vibra
tion.
• The disc is dirty.
• The lens is dirty.
• The headphone plug is dirty.
• The batteries are weak.
• Place the unit in a place not subject
to vibrations.
• Ciean It
• Clean it
■ • Clean it
• Replace or recharge the batteries.
Noise interferes.
• The headphone plug is dirty.
• The batteries are weak,
• The headphones are connected incom
pletely.
• Clean it.
• Replace or recharge the batteries,
• Insert the plug securely into the
PHONES jack.
This system uses a microcomputer so it may malfunction due to external noise or interference. In such
a case, unplug the power cord then plug it again (or remove the batteries and insert them again).
Do not use contactcleanerforihis could cause malfunction. Particularly, contactdeanercontaining oil may
deform plastic parts.
Erroneous operation may occur when the headphone plug is plugged or unplugged; but this is not a
malfunction.