Choosing a priority channel, Drop-out delay – Uniden UH-100 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Choosing a Priority Channel
The starting channel, when Group Scanning is initiated, is always the Priority Channel.
Changing the PRI channel setting while scanning,
eg. PRI Channel is CH17 (476.825 MHz)
a, press
A
, to select a higher channel {scanning pauses)
- or -
to
lU
b. press ▼ , to select a lower channel
tc
lU
Drop-Out Delay
While scanning, the UH-100 stops at a busy channel and receives a transmission.
When the received signal is over, the unit will wait for three seconds for the return of
the signal, othenwise, the radio resumes scanning.
15