Cannondale S440 - Manual (Page 92)

© 2002 Cannondale Corporation - All Rights Reserved
92
2003 Motorcycle OM.fm
WARNING Indicates a potential hazard that could result in serious injury or death.
12. Place a rag between the drive chain and rear
sprocket. Pull the rear wheel back, and tighten the
rear wheel axle nut to 72.0 lbf•ft (98.0 N•m).
13. Check the rear wheel alignment.
14. Install a new cotter pin, and properly bend the tabs
around the axle nut.
15. Measure the drive chain freeplay and adjust if
necessary.
16. Spin the rear wheel a few times to make sure that it
rotates smoothly and that the brake disc is not
rubbing against the brake pads. Then, take the
motorcycle off the stand, roll it forward and backward
a few times, apply the rear brake, and make sure it
operates properly.
Checking the rear end for excessive play
Before every ride, check the rear end for worn or
loose swingarm bearings.
1. Place the vehicle on a stand so that the rear
wheel is off the ground.
2. Hold each side of the swingarm, and try to move
it from side-to-side. If any freeplay is felt, contact
an authorized Cannondale Motorsports Dealer
for servicing.
1. Tabs
1
WARNING
POTENTIAL HAZARD
Riding this vehicle with worn or loose swing-
arm bearings
WHAT CAN HAPPEN
You can lose control of the vehicle resulting
in serious injury or death.
HOW TO AVOID THE HAZARD
Always check the condition of the swingarm
bearings before each ride.