Crimestopper Security Products CS-845RKE - Manual (Page 7)

TRANSMITTER PROGRAMMING
1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3
rd
time. (ON/OFF, ON/OFF, ON) Lights should flash
once and one horn chirp.
2. Push the Program/Override Button for 5 seconds until you hear 3 horn chirps and lights flash 3 times. Release the
Button.
3. Press the #1 (LOCK) on new transmitter – lights will flash for code learn confirmation.
Repeat step 3 for up to 2 additional transmitters. The system will learn a total of 3 transmitter codes.
4. Turn off Ignition.
Note 1: All transmitters must be learned at the time of programming.
Note 2: If only 1 transmitter is being programmed to the system, continue pressing Button #1 until the unit exits
program mode by unlocking the door and flashing the lights 2 times.
DIAGRAM:
IGN
OFF
PAN IC
TURN IGN. ON
3 TIMES:
ON, OFF
ON, OFF
ON.
1 CHIRP
PRESS AND
HOLD BUTTON
PRESS BUTTON 1
1 FLASH
3 CHIRPS
3 FLASHES
1 FLASH
IGN
OFF
TURN IGN. OFF
FOR EACH
TRANSMITTER