Option programming – Crimestopper Security Products GARGOYLE CS-2001FC User Manual
Page 9

OPTION PROGRAMMING
PROGRAMMABLE OPTIONS
1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear a long confirmation chirp.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren will chirp for each button press. DO NOT LOSE COUNT!!
3. When you get to the desired option number, press the appropriate button on the transmitter according to the chart
below. Turn Ignition off. See Below for Option numbers, descriptions, and values. (Button 1 gives a single light
flash/chirp, Button 2 gives two light flashes/chirps, and Button 3 gives three light flashes/chirps.)
4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options, check
operation to see if the option(s) have changed.
PROGRAMMING OPTIONS CHART * = Default
Option # Option Description
BUTTON 1
LOCK
BUTTON 2
UNLOCK
BUTTON 3
TRUNK
1.
Factory Horn Chirps / Pulses
Pulse with
trip only
Arm/Disarm Chirps
& Pulse with trip
Arm/Disarm/Warn Chirp
& Pulse with trip *
2.
Passive Arming /
Passive Chirp Countdown
ON
OFF*
Chirp Countdown
3.
Passive Lock / Cust. Override
ON
OFF*
Custom Override
4.
Ignition controlled Locks
ON*
OFF
Ignition Lock Only
5.
10/60 Sec. Door Open
Warning
10 Sec.
60 Sec.*
6.
Active Re-Arm
ON*
OFF
7.
Double Unlock Pulse
OFF*
ON
8.
Silent Arm/Disarm
(Chirp Defeat)
OFF*
ON
9.
Parking Lights on with disarm
ON*
OFF
10.
Disarm with trunk pop
OFF
ON*
11.
Silent Arm/Disarm with
Remote (Button 3)
ON*
OFF
12.
Door Lock Pulse Time
0.7 Sec.*
3 Sec.
13.
Type of Carjack Protection
ACTIVE*
PASSIVE
FULL-TIME
14.
Carjack Enable/Disable
DISABLE*
ENABLE
NOTE: Options can be instantly restored to Factory Default Values: To restore default values: Perform step #1 above,
then press button #3 (Trunk). The siren will chirp 4 times and lights will flash 4 times. Turn OFF Ignition. All
programming options should be restored to “*” values (See chart above).