Bosch WTMC5321US/CN - Manual (Page 18)

7. Re-insert the lint filter.
Cleaning and care
Cleaning the dryer
A WARNING A
TO AVOID
RISK OF EXPLOSION!
Never use solvents or highly
flammable liquids for cleaning.
ATTENTION
Incorrect cleaning may damage the
dryer. Do not spray with a water jet.
Do not use scouring agents or
all-purpose cleaners. Do not use
steam cleaners.
Wipe the housing and fascia with a soft
cloth and soapy water only.
Wipe the drum, door seal and inside of
the door with a damp cloth only.
Cleaning the lint filter
A dirty filter extends the drying time and
increases energy consumption.
The filter should be cleaned before and
after each drying process.
If a warning signal and an E01 warning
message are emitted during a drying
program, clean the filter immediately
and check the exhaust duct.
E The program interrupts
automatically.
1. Switch off the dryer. Program
selector to “Off”.
A CAUTION
The inside of the door heats up
during the drying process.
2. Open the door.
3. Remove the lint filter.
4. Remove lint by stroking your hand
over the filter.
The filter should be lightly scrubbed
twice a year with warm soapy water.
The filter is cleaned when it no longer
holds water. The filter must be dried
thoroughly before being replaced.
5. Insert the filter.
6. Close the door.
Cleaning the exhaust duct
Inspect and clean the exhaust ducting
at least once a year to prevent
clogging. A partially clogged exhaust
can lengthen the drying time.
□
Turn off the circuit breaker
□ Pull out power supply plug
□ Disconnect the duct from the
dryer.
□ Vacuum and reconnect the duct.
Cleaning the moisture
sensor
The moisture sensor has to be cleaned
because a fine layer of transparent
buildup is deposited on the sensors.
18