Program selection, Time programs, Automatic programs – Bosch WTMC5321US/CN User Manual
Page 14: Options, Indicator of program sequence
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Program selection
Time programs
For optimum drying resuits your dryer
offers severai program groups and
additionai options.
Seiect the required drying program
from the program tabie according to
the exampies (see page 15).
Automatic programs
There are automatic programs for
different types of textiies.
(Reguiar/Cotton ECOSENSOR or
Permanent Press ECOSENSOR).
Reguiar/Cotton
ECOSENSOR
Permanent Press
ECOSENSOR
The program sequence of automatic
programs is controiied via sensors. The
duration of the program depends on
the measured degree of moisture in the
iaundry and on the seiected degree of
dryness (e.g. Damp dry or Extra dry).
Time programs run for a specific time
(20, 40, 60 minutes).
in the ”Air fiuff/No heat” stage the dryer
runs on ambient air without a heat
suppiy for 20 minutes.
I
i
I Dry wooien or wooi-rich textiies
with dryer rack oniy!
Options
Delicates low temp.
Press the ”Deiicates iow temp.” button
for temperature sensitive textiies.
Observe the care information or
symbois on the textiies. The
temperature of the drying process is
reduced, the drying time is extended.
Signal
Your dryer outputs different signais, if
the ”Signai” button is pressed.
Signal
Type
Start
Short tone
End
Sequence of short
tones
Mal-operation
Sequence of iong tones
Warning of
Sequence of iong tones
malfunction
rn The signai
“Warning of maifunction” is active
in any case.
Indicator of program
sequence
The dryer uses an eiectronic scanning
system for aii programs except the time
programs . A moisture sensor
continuousiy checks the moisture in the
iaundry. Drying ends automaticaiiy as
soon as the seiected degree of dryness
has been reached.
The drum continues to rotate at
specific intervais for one hour to
prevent creasing.
The current degree of drying and the
ievei reached during the program
sequence is indicated via indicator
iights (Drying, Damp dry, Reguiar dry,
Wrinkie biock).
m
if the indicator iight “Wrinkie biock”
iiiuminates when the program
seiector is in Off-Position - turn off
the circuit breaker and caii for
customer service!
14