If ac is blocked by storm window, Removing ac from window, Installation instructions – Sharp AF-S85NX User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

INSTALLATION INSTRUCTIONS

Place the frame lock between the frame

extensions and the window sill as shown

(FIG.8). Drive 3/4"(19mm) locking

screws through the frame lock and Into the sill
(FIG.9). NOTE: To prevent window sill from
splitting,drill 1/8"(3 mm) pilot holes before
driving screws.

FIG. 8

Cut foam seal and Insert in the space
between the upper and lower sashes
(FIG.12).

Drive 3/4" (19mm) locking screws

through frame holes into window sash

(FIG.10).

If AC is Blocked by Storm
Window

Add wood as shown in FIG. 13, or remove storm
window before air conditioner is installed.

FIG. 13

STORM WINXIW

FRAME

OTHER

11i2"MIN

OBSTRUCTION (38 mm)

BOARD

THICKNESS
AS REQUIRED,

FOR PROPER
PITCH TO
REAR. ALONG
ENTIRE SILL.
FASTEN WITH
NAILS OR
SCREWS.

To secure lower sash in place, attach right angle

window lock with 3/4" (19 mm) screw as shown

(FIG. 11).

If Storm Window Frame must remain, be sure the

drain holes or slots are not caulked or painted shut.

Accumulated Rain Water or Condensation must be

allowed to drain out.

Removing AC From

Window

Jk Turn AC off, and disconnect power cord.
¡k Remove sash seal from between windows,

and unscrew safety lock.

Hi Remove screws Installed through frame and

frame lock.

>k Close(slide) side panels into frame.
H: Keeping a firm grip on air conditioner, raise

sash and carefully “rock” air conditioner

backward to drain any condensate water in
base of unit. Be careful not to spill any
remaining waterwhile lifting unit from

window. Store parts WITH air conditioner.