Sharp AF-S85NX - Manual (Page 7)

INSTALLATION INSTRUCTIONS
NOTE: Top Rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of(5/16').
This is necessary for proper condensed water utlilzation
and drainage. If you are not using the Side Panels for
any reason, this pitch to the rear must be maintained!
3 Place unit on floor,a bench or a table,There Is a
Left and Right Window Filler Panel-be sure to
use the proper panel for each side. When installed
the flange for securing the panel to the window sill will be
facing Into the room.
A. Hold the Accordion Panel in one hand and gently
pull back the panel beyond the ends of the frame.
B. Slide the free end (T section) of the panel into the
cabinet as shown in FIG 3, & 4. Slide the panel down.
Be sure to leave enough space to slip the top and bottom
of the frame into the rails on the cabinet.
C. Once the panel has been Installed on the side of
the cabinet, make sure it sits securely inside the frame
channel. Slide the top and bottom ends of the frame
into the top and bottom rails of the cabinet. FIG 5.
D. Slide the panel all the way In and repeat on the other
side.
NOTE: If storm window blocks AC,see FIG.13
4 Keep a firm grip on the air conditioner,carefully
place the unit into the window opening so the
bottom of the air conditioner frame is against the
window sill (FIG.6). Carefully close the window behind the
top rail of the unit.
FIG. 6
Extend the side panels out against the window
frame (FIG.7).