Kenmore Coldspot 106 - Manual (Page 5)

AWARNING
>8
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its finai location, it is
important to make sure you have the proper eiectricai
connection:
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded
electrical supply is required, it is recommended that a separate
circuit serving only your refrigerator be provided. Use an outiet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of instailation, cleaning, or
removing a iight buib, turn the control, (Thermostat, Refrigerator
or Freezer Controi depending on the model) to OFF and then
disconnect the refrigerator from the eiectricai source. When you
are finished, reconnect the refrigerator to the eiectricai source
and reset the controi (Thermostat, Refrigerator or Freezer Controi
depending on the modei) to the desired setting.
To remove the base grille:
1. Open both refrigerator doors.
2. Place hands along the ends of the grille, with your thumbs
aiong the top. Push in with your thumbs and puii up on the
bottom.
NOTE: Be sure to refasten the Tech Sheet behind the base griile
after cieaning.
To replace the base grille:
1. Open the doors.
2. Line up the griiie support tabs with the metal clips.
3. Push the griiie firmly to snap it into place.