General information, Care of the unit, Troubleshooting – Brother AX-325 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
General Information
Your typewriter comes with the following items:
•
Cassette ribbon
»
Cassette daisy wheel
•
Correction tape
Please make sure that these items are included with the machine
The power cord is stored in a compartment
on the back of the machine.
The power switch is located on the left side
of the typewriter near the rear.
^
Power Coro
■ ComoarEmeni
Care of the Unit
Beware of tiny objects
Cleaning
Location
Ventilation
Power Cord
Take precautions to prevent anything from slipping into the type
writer or between the keys. Be especially careful of metal objects
such as paper clips and staples.
Never use volatile liquids such as thinner or benzine to clean the
exterior surface of the typewriter. Use only a soft cloth dampened
with a mild detergent solution.
Do not expose your typewriter to direct sunlight, heat or intense
vibration. Be sure to replace the keyboard cover when the type
writer is not in use.
Do not block the ventilation slits provided at the back of the unit to
prevent overheating.
Troubleshooting
Problem
Possible cause
Nothing happens when power
switch is turned on
1. Is the power cord plugged in?
Poor printing performance or
printout is impossible
1, Is the daisy wheel properly installed? (Has the lever been
pressed firmly?) Is the correct daisy wheel installed?
2- Have you run out of ribbon?
3. Have you
pressed :$ + // Keys aner replacing cassenc
ribbon, correction tape or daisy wheel?
Poor correction performance
1. Has the correction tape been properly installed?
2. Have you run out of correction tape?
3. Are you using the proper correction tape?
-Page 13-