Replacing the correction tape – Brother AX-325 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacing the correction tape
Two types of correction tape are available:
•
Lift-off correction tape, to be used correctabie
film ribbon.
•
Cover-up correction tape, to be used nylon nbbon.
To replace the correction tape:
1) Use
[SPACE BAR]
or
|en
to move the carrier to the
centre of the platen.
2) Open the top cover.
3) Remove the cassette ribbon, if installed.
4) Pull off both spools, pressing against the correction
tape with your thumbs. Bring it back to a position
parallel with the platen, and lift It up and out.
5) Pass the new tape through the left guide, behind the
ribbon guide, and out through the right guide. The
rough (sticky) side of the tape should face the platen.
6) Attach the feeder spool to the pin on the left.
7) Attach the take-up spool to the pm on the right.
8) Turn the take-up spool counter-clockwise until a small
amount of white tape has wound around it.
9) Replace the cassette ribbon and close the top cover.
10) Press ]^ + // to move the carrier to the previous
position.
-Page 11-