Materials and basic tools needed, Materials needed, Basic tools – Kenmore POWER MISER 153.336851 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To simplify the installation Sears has available the installation
parts shown below. You may or may not need all of these materi-
alsi depending on your type of instulation.
VENT ELBOW
WATER HEATER INSTAL
LATION KIT WITH FLEXI
BLE CONNECTORS FOR
3/4" OR 1/1" THREADED
OR COPPER PLUMBING
0
WATER HEATER STAND 14"xl4"xl8"
FOR USE WITH WATER HEATERS
INSTALLED IN RESIDENTIAL
GARAGES HAVING A DIAMETER 24"
OR LESS AND A RATED CAPACITY TS
GALLONS OR LESS
EXPANSION TANKS
FOR THERMAL
EXPANSION CONDI
TIONS AVAILABLE IN
2 GALLON AND 5
GALLON CAPACITY
THROUGH LOCAL
SEARS STORE OR
SERVICE CENTERS
FLEXIBLE WATER
HEATER GAS CON
NECTOR WITH
FITTINGS
VENT PIPE
WATER HEATER HEAT
TRAPS HELP REDUCE HEAT
LOSS DUE TO THERMAL
SYPHONING
DRAIN PANS
AVAILABLE IN 10" DIAMETER FOR
WATER HEATERS HAVING A DIAME
TER 18" OR LESS AND AVAILABLE IN
IS" DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 18" OR LESS
Basic Tools
You may or may not need all of these tools, depending on raur
type of installation. These toob can be purchased at your local
Sears store.
• Pipe Wrenches (2) 14"
• Screwdriver
• Tin Snips
• 6 Foot Tape of Folding Ruie
• Garden Hose
•Drili
• Pipe dope or Teflon Tape
GARDEN HOSE
4 FOOT TAPE
PIPE
WRENCH
SLOT-HEAD SCREWDRIVER
PHILLIPS SCREWDRIVER
TIN SNIPS
ROLL OF TEFLON TAPE
(USE ONLY ON WATER
CONNECTIONS)
PIPE DOPE (SQUEEZE TUBE)
USE FOR WATER AND
AS CONNECTIONS)
a
ADDITIONAL
TOOLS
NEEDED
WHEN SWEAT SOLDERING
• Tubing Cutters or Hacksaw
• Propane Torch
* Soft Solder
* Solder Flux
* Emery Cloth
• Wire Brushes
( iar
HACKSAW
3/4 WIRE BRUSH
t/1" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
ROLL OF EMERY
CLOTH
SOLDER FLUX
PROPANE
TORCH
TUBING
CUTTER