Pioneer PD-F706 - Manual (Page 14)

TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the
points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer
to carry out repair work.
Symptom Probable cause Remedy
No sound • Output cables are connected incorrectly or loosely. • Connect properly.
• Incorrect operation of stereo amplifier. • Check the settings of amplifier switches and
sound volume controls.
• Pin plugs and/or amplifier terminals are dirty. • Clean away dirt.
• Player is in pause mode. • Press ► or II.
• The disc is loaded with the label side leftward. • Reload the disc with the label side rightward.
When playback is started, it
stops immediately.
• Disc is inserted in the wrong way. • Insert the disc correctly with the label side
rightward.
Pauses or stops during playback. • Smudges, etc., on the disc. • Clean the smudges from the disc and then play
it again.
Remote control will not func­ • Dead batteries. • Replace batteries.
tion. • Obstruction between player and remote control
unit.
• Relocate remote control unit or remove ob­
struction.
Abnormal functioning of this unit may be caused by static electricity, or other external interference. To restore normal operation, or unplug the AC
power cord and then plug it in again.
SELF-DIAGNOSTICS FUNCTION
The unit incorporates the self-diagnostic function.
When an abnormality is detected during operation of the unit, an error message (service No.) appears on the unit's display automatically. Treat the
error by following the instructions in "Countermeasures".
Display on the unit
Service No.
Service No. Unit Status Countermeasures
U1 The disc may not be loaded properly in the rack.
• Reload the discs properly.
(Insert only one disc in a slot.)
• Check if there is a foreign object attached onto
the disc.
• Check if there is a foreign object in the rack.
U2 There is an operation error in the mechanical section. • Check if there is a foreign object in the rack.
• Unplug the power cord then plug it in again.
U3 There is an operation error in the CD SLOT section.
• Replace the disc properly.
(Insert only one disc in the CD SLOT.)
• Unplug the power cord then plug it in again.
If the same display appears again, there may be an error in the mechanical section. When requesting servicing, please also let us know the
service number displayed on the unit.
14
En