Remember, Before setting surface controls – Kenmore ELITE 790.3105 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Check Burner Cap Placement Before Operating
the Surface Burners
To prevent flare-ups
and
avoid creation
of
harmful by
products, do not use the cooktop v/ithout all burner caps
properly installed to insure proper ignition and
gas
flame size.
It is very important to be sure that all surface burner caps
and burner grates are properly installed and in the correct
locations BEFORE operating the cooktop burners.
Remember:
• Always
keep surface burner caps in place whenever using
a surface burner.
• When placing the burner caps, be sure that all burner caps
are seated firmly and rest level on top of burner heads.
•
For proper flow of gas and ignition of burners DO NOT
allow spills, food, cleaning agents or any other material
to enter the gas orifice port opening.
Round Style Burners
The burner cap lip (See Fig. 1) should fit snug into the center
of burner head and rest level. Refer to Figs.
2 & 3
for correct
and incorrect burner cap placement. Once in place, you
may check the fit by gently sliding the burner cap from side
to side (Fig. 4) to be sure it is centered and firmly seated.
When the burner cap lip makes contact inside the center
of the burner head you will be able to hear the burner cap
click. Please note that the burner cap should
NOT
move off
the center of the burner head when sliding from side to side.
Before Setting Surface Controls
Burner Cap
Burner Head
Burner Cap Lip
Fig. 1
Correct Burner Cap
Placement
Fig.
2
Incorrect Burner Cap
Placement
Fig. 3
¥
Fig.
4
10