Care and maintenance – Kenmore PLASMAWAVE 85450 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
AIR QUALITY SENSOR: The air quality
sensor displays five levels of impurities
in the air. If the unit is set to automatic
operation, the air qualify sensor will adjust
fan speeds according to the air quality; fan
speed will decrease as air quality improves.
The AIR QUALITY sensor responds to
cigarette smoke and pet odors, as well as
other contaminants, such as insecticides,
cosmetics, and alcohol or aerosol sprajiS.
The AIR QUALITY LEVEL indicator shows
three colors: blue, orange, and red. The
blue light indicates clean air, the orange
light indicates unciean air, and the red iighl
indicates very unclean air. If the unit is set
to automatic operation, It will change fan
speeds to compensate for different levels
of air pollution.
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer
ence to radio communications. However,
there Is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try
to correct the interference through one or
more of the following:
» Reorient or relocate the receiving
antenna.
• increase the distance between the
equipment and the air cleaner.
• Connect the air cleaner to an outlet on
a circuit different from that to which the
equipment Is connected.
«Consult an experienced television/
radio technician.
CARE AND MAINTENANCE
CAUTION: Turn off the air cleaner and unplug the electrtcai cord before performing
any maintenance.
Cleaning
• Clean unit as necessary by wiping with a
dry, soft cloth; for stubborn stains, use a
warm, damp cloth.
• Do not use volatile fluids such as ben
zene, paint thinner, or scouring powder,
as they may damage the surface.
• Keep the unit dry.
• Lightly vacuum the AIR QUALITY sensor
every three months.
AIR QUALITY SENSOR