Kenmore PLASMAWAVE 85450 - Manual (Page 11)

REMOTE CONTROL
î
B54
î
)D B5300:Hnly;
BATTERY REPLACEMENT
1. Squeeze lab of battery cover,
2. At the same time pull cover out of remote.
3. Insert battery as shown.
4. Close the battery cover.
CRADLE: The remote control
has a separate wali-mountable
storage cradle that can
be conveniently attached to
any wall using a screw,
BATTERY USE
>» Insert 3V lithium battery CR2025 into the
remote control.
• Incorrect battery usage may cause battery
fluid leakage and/or damage.
» When not using remote control for an ex­
tended period, remove the battery.
• Avoid dropping or damaging the remote
control. Keep remote control away from
direct sunlight or heaters.
PROPER OPERATING CONDITIONS
• Operate the remote control facing the air
cleaner.
• Operate within 20 feet of the air cleaner.
IMPROPER OPERATING CONDITIONS
« Any location where there is inverter light­
ing equipment or electronic spontaneous
lighting equipment,
• When objects or furniture are located
between the remote and the air cleaner.
• When air cleaner unit is located in direct
sunlight, as sunlight may interfere with the
infrared sensor,
• In areas where fluorescent lighting is
flickering due to worn-out bulbs.
A. POWER; Use the power button to turn
the power on and off A short “beep" will
sound when the unit turns on or off.
B. AUTO: When in AUTO mode, the air
cleaner will automatically sense the
amount of impurities in the air and adjust
the fan speed accordingly. When the
unit Is first turned on it will default to
AUTO mode.
C. FAN SPEED
* UP; Use this button to switch from
automatic operation and increase the
fan speed.
® DOWN: Use this button to switch from
automatic operation and decrease the
fan speed.
D. TURBO; Use this button to switch from
automatic operation and begin the
maximum amount of room air cleaning
and air movement.
12