Typical in and out pipes to filter, Plan your installation, Typical in and out pipes to filter fig. 2 – Kenmore 7146611 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2
PLAN YOUR INSTALLATION
:
20
.
TYPICAL IN AND OUT PIPES TO FILTER
FIG. 2
IN AND OUT PLUMBING USING
A 3 VALVE BYPASS
(SOLDERED OR CPVC PLASTIC)
SEARS KITS AND VALVES
TO MAKE INSTALLING
YOUR FILTER EASIER
BYPASS VALVE (Plastic)
Sears Stock No. 42-3437
One, easy working valve takes the
place of 3 separate valves.
INSTALLATION KIT
Sears Stock No. 42-3441
USE TO REPLACE THE 1 ” X 3/4”
SWEAT ADAPTORS INf A) ANDfe/.
FLEXIBLE CONNECTORS
Sears Stock No. 42-3440
Allows easy hook up even if
pipes are not exactly aligned.
(CHECK LOCAL PLUMBING CODES)
CONNECT FROM IN
OUT PIPES, AT DOTTED
LINE, DIRECTLY TO
THE INLET AND
OUTLET ADAPTORS
OR TO BYPASS
VALVE 0 . SEE0,
(©,AN
d
T"'''
CROSS-OVER
USE IF WATER SUPPLY
IS FROM THE LEFT
IN AND OUT PLUMBING
, USING SEARS SPECIAL PLASTIC
BYPASS VALVE
(SOLDERED OR CPVC PLASTIC)
filtered —_
'Vater ^
OUT
r NPT X
%" Sweat
Reducer (2)
Outlet
Paucef
FITTINGS
REQUIRED NOT
IDENTIFIED
90“ Elbow (2)
Pipe (as reg.)
VALVE
FILTER
IN AND OUT PLUMBING USING
SEARS PLASTIC BYPASS VALVE
(THREADED PIPE)
'^'tered
'Vater
OUT
Outside
Faucets
FITTINGS
REQUIRED NOT
IDENTIFIED
90“ Elbow (2)
Union (2)
Pipe (as reg.)
FILTER
1 " X 3 4" reducer*
VALVE