Connect drain hoses – Kenmore 7146611 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 4

STEP BY STEP GUIDES TO INSTALL

4D.

CONNECT DRAIN HOSES

IF INSTALLING A CLARIFIER, NEUTRALIZER OR TASTE
& ODOR FILTER, SKIP PAGE 15 AND GO TO PAGE 16.

2. CONNECT THE BOTTLE DRAIN TUBING
AUTOMATIC IRON FILTER

Connect a length of 5/16” plastic tubing to the vent fitting
on the feeder valve (Figure 11) using a nut ferrule. Put the
other end of the tubing over the drain and fasten it to the

valve drain hose so it stays over the drain. If a copper

drain is needed, get the tubing and fittings shown it Fig
ure 11.

WARNING:

THIS DRAIN (VENT) MUST ALWAYS BE OPEN TO AL

LOW AIR TO ENTER AND LEAVE THE BOTTLE. IF
PLUGGED, THE BOTTLE WILL COLLAPSE. IF THE
BOTTLE OVER FILLS, SOME POTASSIUM PERMAN
GANATE SOLUTION COULD COME FROM FROM

THE DRAIN TUBING. BE SURETHE ENDOFTHETUB-

ING IS ALWAYS OVER THE DRAIN.

FIG. 11

BOTTLE DRAIN TUBING, AUTOMATIC

IRON FILTER