Restart the water heater – Kenmore 7146611 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 4

STEP BY STEP GUIDES TO INSTALL

RESTART THE WATER HEATER

TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT.

NOTE:

Your new Sears filter is now filtering the water for your

household needs. However, your

WATER HEATER Is

filled with unflltered water.

To have fully filtered water

right away, you can drain the water heater so it refills with

filtered water. If you don’t drain it, it will take a few days

before you have fully filtered water.

To drain the water heater, open a hot water faucet and let

it run until the water turns cold. Then close the faucet.

YOUR PLUMBING AND ELECTRICAL WORK IS COMPLETE. NOW GO TO YOUR OWNERS MANUAL AND DO THE

FILTER START UP STEPS ... setting the timer, sanitizing, etc.