Install three valve bypass – Kenmore 7146611 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 4

STEP BY STEP GUIDES TO INSTALL

4B.

INSTALL THREE VALVE BYPASS

INSTALLING THREE VALVE BYPASS AND PIPES

(FIGURE 8).

Cut the house main water pipe where you will connect

the filter. Loosely put together pipe, fittings and the three
valves. Place valves within easy reach.

IMPORTANT: WHEN LOOKING AT THE FRONT OF THE
FILTER, THE INLET IS ON THE RIGHT SIDE. IFTHE WA

TER IN YOUR HOUSE MAIN WATER PIPE RUNS FROM

LEFTTO RIGHT, BE SURE TO USE A “CROSS OVER” AS

SHOWN ON PAGE 9.

b. When all pipe, fittings and valves make a food fit to
gether, tighten all threaded joints (use pipe dope on out

side threads), or solder.

FIG. 8

BYPASS VALVE

3-VALVE BYPASS

(threaded plumbing shown)

Inlet