beautypg.com

Refrigerator use, Ensyririg vmpm k, Adjusting controls – Kenmore WIOI67097A User Manual

Page 10: Refrigerator, The water dispenser, Refrigerator care, Ii i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Rattling noises may come from the flow of refrigerant, the

water line, or items stored on top of the refrigerator.

Water dripping on the defrost heater during a defrost cycle
may cause a sizzling sound.

As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your refrigerator.

Contraction and expansion of the inside walls may cause a
popping noise.

You may hear air being forced over the condenser by the
condenser fan.

You may hear water running into the drain pan during the
defrost cycle.

REFRIGERATOR USE

Ensyririg vmpm k

In order to ensure proper temperatures, you need to permit air to

flow between the two sections. Cold air enters the bottom of the
freezer section and moves up. It then enters the refrigerator
section through the top vent. Air then returns to the freezer as
shown.

or

ii

i/

Do not block any airflow vents. If the vents are blocked, airflow

will be obstructed and temperature and moisture problems may
occur.

IMPORTANT: Because air circulates between both sections, any

odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.

■ Settings to the left of the mid-setting make the temperature

less cold. Settings to the right of the mid-setting make the
temperature colder.

■ Wait 24 hours before you put food into the refrigerator. If you

add food before the refrigerator has cooled completely, your
food may spoil.

NOTE: Adjusting the Refrigerator and Freezer Controls to a
higher (colder) than recommended setting wili not cool the
oompartments any faster.

Adjusting Controls

NOTE; Give the refrigerator time to cool down completely before
adding food. It is best to wait 24 hours before you put food into

the refrigerator. The settings indicated in the previous section
should be correct for normal household refrigerator usage. The
controls are set correctly when milk or juice is as cold as you like
and when ice cream is firm.
■ Slide the control one setting to the right to make the

compartment colder.

■ Slide the control one setting to the left to make it less cold.

If you need to adjust temperatures in the refrigerator or freezer,

use the settings listed in the chart below as a guide. Wait at least
24 hours between adjustments.

CONDITION/REASON:

ADJUSTMENT:

REFRIGERATOR too warm

REFRIGERATOR Control
one setting higher

FREEZER too warm/

FREEZER Control

too little ice

one setting higher

REFRIGERATOR too cold

REFRIGERATOR Control
one setting lower

FREEZER too cold

FREEZER Control
one setting lower

Disabling Sounds

To turn off all dispenser and control sounds, press and hold

ICE and FILTER at the same time for 3 seconds.

To turn all sounds back on, press and hold ICE and FILTER at
the same time for 3 seconds again.

For your convenience, your refrigerator controls are preset at the

factory. When you first install your refrigerator, make sure that the
controls are still preset. The Refrigerator Control and the Freezer
Control should both be set to the “mid-settings.”

Freezer

Refrigerator

cold 1

2

3 4 colder

IMPORTANT:

oft

3 4 colder

Your product will not cool when the REFRIGERATOR Control
is set to OFF.

The Refrigerator Control adjusts the refrigerator compartment
temperature. The Freezer Control adjusts the freezer
compartment temperature.

Depending on your model, you may have one or more of the

following options; the ability to select either crushed or cubed

ice, a special light that turns on when you use the dispenser, or a
iock option to avoid unintentional dispensing.

The Water Dispenser

If you did not flush the water system when the refrigerator was

first installed, do so now. Use a sturdy container to depress and

hold the water dispenser lever for 5 seconds, then release it for
5 seconds. Repeat until water begins to flow. Once water begins

to flow, continue depressing and releasing the dispenser lever
(5 seconds on, 5 seconds off) for an additional 2 minutes. This
will flush air from the filter and water dispensing system.
Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of

the dispenser.
Allow 24 hours for the refrigerator to cool down and chill water.

10