Kenmore 153.337002 - Manual (Page 7)

Materials and Basic Tools Needed
Materials Needed
To simplify the installation Sears has available the installation
parts shown below. You may or may not need all of these materi­
als, depending on yonr type of installation.
FLEXIBLE WATER
HEATER GAS CON­
NECTOR WITH
FITTINGS
WATER HEATER STAND 24"x24"xl 8"
FOR USE WITH WATER HEATERS
INSTALLED IN RESIDENTIAL
GARAGES HAVING A DIAMETER 24"
OR LESS AND A RATED CAPACITY 7S
GALLONS OR LESS
VENT ELBOW
EXPANSION TANKS
FOR THERMAL
EXPANSION CONDI­
TIONS AVAILABLE IN
2 g V^ llon and S
GALLON CAPACITY
THROUGH LOCAL
SEARS STORE OR
SERVICE CENTERS
c
VENT PIPE
DRAIN PANS AVAILABLE IN 28"
DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 28" OR LESS
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
• Pipe Wrenches (2) 14"
• Screwdriver
• Tin Snips
• 6 Foot Tape of Folding Rule
• Garden Hose
• Drill
• Pipe dope or Teflon Tape
GARDEN HOSE
6 FOOT TAPE
SLOT-HEAD SCREWDRIVER
PHILLIPS SCREWDRIVER
PIPE
WRENCH
ADDITIONAL TOOLS NEEDED
WHEN SWEAT SOLDERING
• Tubing Cutters or Hacksaw
• Propane Torch
• Soft Solder
• Solder Flux
• Emery Cloth
• Wire Brushes
HACKSAW
\
A
l J
TIN SNIPS
c
ROLL OF TEFLON TAPE
(USE ONLY ON WATER
^ CONNECTIONS)
PIPE DOPE (SQUEEZE TUBE)
(USE FOR WATER AND
GAS CONNECTIONS)
3/4" WIRE BRUSH
‘ WIRE BRUSH
PROPANE
TORCH
ROLL OF LEAD FREE
SOFT SOLDER
3
ROLL OF EMERY
CLOTH
SOLDER FLUX TUBING
CUTTER