Kenmore 790. 9021 - Manual (Page 24)

Before You Call ® Solutions to common problems
Problem
Oven smokes excessively v/hen broiling.
Solution
• Incorrect setting. Follow broiling instructions in Setting Oven Controls
section.
• Be sure oven door is opened to broil stop position when broiling.
• Meat too close to the broil element. Reposition the broil rack to provide
proper clearance between the meat & the element. Preheat the broil
element for searing.
• Meat not properly prepared. Remove excess fat from meat. Cut remaining
fatty edges to prevent curling, but do not cut into lean.
• Grease has built up on oven surfaces. Regular cleaning is necessary when
broiling frequently. Old grease or food spatters cause excessive smoking.
Flames inside oven or smoking from oven
vent.
Excessive spillovers in oven. For example this will happen for pie
spillovers or large amounts of grease left on the oven bottom. Wipe up
excessive spillovers before starting oven. If flames or excessive smoke
are present see Broil in Setting Oven Controls section.
Oven control panel beeps & displays
any F code error.
Oven control has detected a fault or error condition. Press
stop
key pad to
clear the error code. Try Bake or Broil function. If the F code error repeats,
remove power from appliance, wait 5 minutes and then repower appliance
and set clock with the correct time of day. Try Bake or Broil function again.
If the fault recurs, press
stop
to clear and call 1-800-4-MY-HOME® for
assistance (See back cover).
Select Clean does not work. • Oven control not set properly. Review instructions in Select Clean section.
Soil not completely removed after
running Select Clean cycle.
Select Clean was interrupted. See Select Clean instructions.
Excessive spillovers on oven bottom. Remove before starting Select Clean.
Failure to clean soil from the oven frame, the door liner outside the oven
door gasket and the small area at the front center of the oven bottom.
These areas are not in the self-cleaning area, but get hot enough to burn
on residue. Clean these areas before the self-cleaning cycle is started.
Burned-on residue can be cleaned with a stiff nylon brush and water or a
nylon scrubber. Be careful not to damage the oven gasket.
Oven racks discolored. Oven racks left in oven cavity during Select Clean. Always remove oven
racks from oven cavity before starting a self-clean cycle. Clean by using a
mild, abrasive cleaner following manufacturer's instructions. Rinse with clean
water, dry and replace in oven.
24