beautypg.com

Care & cleaning, Raising and lowering the cooktop (some models), Replacing oven light (some models) – Kenmore 790. 9021 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Raising and lowering the cooktop

(some models)

Care & Cleaning

A WARNING

To avoid possible burns DO NOT turn

the surface elements on when the cooktop is raised. Be

sure that the top is completely lowered and securely in

place before turning on any of the surface burners.

ii CAUTION

I

When lowering the lift-up range cooktop,

grasp the sides with fingertips only. Be careful not to

pinch fingers. Do not drop or bend the cooktop when

raising or lowering. This may permanently damage the

cooktop surface.

To raise and lower the cooktop:

1. Remove all items from cooktop and set aside.

Grasp the sides of the cooktop and then lift from the

front (See Fig. 1).

Lift the cookop high enough to allow the support rods

to snap into place. The lift-up rods will support the

cooktop in the raised position.

If necessary, clean underneath using hot, soapy water

and a clean cloth; then dry.

To lower the cooktop, grasp the front corner of each

side of the top while pushing back on each rod with

the heel of your hand. This will release the notched

support. Hold the range cooktop and gently slide the

top back down level to the range.

2

.

3.

4.

5.

Replacing oven light

(some models)

ik CAUTION

Be sure the range is unplugged and all parts

are COOL before replacing oven light. Wear a leather­

faced glove for protection against possible broken glass.

The oven light is located at the rear of the oven cavity and

is covered with a glass shield held by a wire holder. The

glass shield protects the light bulb and must be in place

whenever the oven is in use.

To replace the interior oven light bulb:

1. Turn electrical power off at the main source or unplug

the range.

2. Press wire holder to one side to release the glass shield

that covers the light bulb.

3. Replace light with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder

back into place.

5. Turn power on at the main source (or plug the appliance

in).

6. The clock will then need to be reset. To reset, see

Setting clock in this Use & Care Guide.

21