Warning, Caution, Agitator cleaning – Kenmore 116.31912 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit. Failure
to do so could result in electrical shock
or personal injury from cleaner sud
denly starting.
TO REMOVE LIGHT BULB
Disconnect power cord from electrical out
let.
Pry light lens
out at slot in
rear as shown
on both sides.
Rotate lens up
and lift off.
A
CAUTION
Do not use a bulb rated over 9W (13V).
During extended use, heat from the bulb
could overheat surrounding plastic
parts.
To replace
the light
bulb careful-1
ly insert fully
into slot.
Note: See PARTS AND FEATURES for bulb
number.
A
CAUTION
Do not plug in or turn on until the vacu
um is cwnpleteiy reassembled.
To replace light
lens, place tabs
at front of lens
into slots. Rotate
lens down and
snap into place.
Light
Lens
^
AGITATOR CLEANING
To maintain efficient cleaning, the agitator
must be kept free of carpet pile, string, or
hair build-up. After every 7 to 10 uses,
unplug and turn vacuum over and check
agitator for string and hair build-up.
Use a scissors to remove any build-up
entangled around the agitator.
17