Adjusting the air adjustment shutter if necessary, Step 9, Leveling the range – Kenmore 362.72239 User Manual
Page 38: Installation instructions (continued), Step 9 leveling the range
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS (continued)
CTpp ft
H I
hhm
H
Adjusting the Air Adjustment Shutter
If Necessary
To determine if the oven burner flames are burning
properly, first remove the oven bottom.
To remove the oven bottom:
1. Remove the knuried
screws holding down
the rear of the oven
bottom.-
2. 6rasp the oven
bottom at the finger
slots on each side.
3. Lift the rear of the
oven bottom enough
to clear the lip of the range frame, push it back, and
then puli it up and out.
With the oven bottom
removed, properly
adjusted flames should
have approximately
(2.5 cm) blue cones
and, if range is supplied
with natural gas, should
burn with no yellow
tipping. (With most LP
gas, small yellow tips at the end of outer cones are
normal) Flames should not lift off the burner ports.
If lifting is observed, gradually reduce air shutter
opening until flames are stabilized.
The shutter lor the oven burner is near the back wall of
the oven and behind the broiler drawer. To remove the
broiler drawer:
1. Pull the drawer out until it slops, then push it back in
about 1" (2.5 cm).
2. Grasp the handle, lift and puli the broiler drawer out
LoQssn
Air acfjustmeni shutter
Remove the metal
shield at the rear of
the drawer cavity.
The air adjustment
shutter is behind
this shield. To adjust
the flow of air to
the burner, loosen
the Phillips-head
screw and rotate
the shutter to allow
more or less air
into the burner tube.
STEP 9
Leveling the Range
1. Install the oven shelves
in the oven, then position
the range where it will be
installed
2. Check for levelness by
placing a spirit level or a
partially filled cup of water
on one of the oven shelves.
If using a spirit level, take
two readings—with the leve
placed diagonally first in
one direction and then the
other.
3. Remove the broiler drawer. The front leveling legs can
be adjusted from the bottom and the rear legs can be
adjusted from the top or the bottom.
Raiss
range
Lower
range
(on some models)
4. Use an open-end or
adjustable wrench to
adjust the leveling legs
until the range is level
5. After the range is level,
slide the range away
from the wail so that the
Anti-Tip device can be
installed.
Lower
range
Leg
leveler
Raise
range
(on some rtrodete)
38