Kenmore 630.1391 - Manual (Page 15)

OPERATING THE DISHWASHER
Smart Pots &
Wash*'^ Pans
Norma! China Fast
Wash Gentle Wash
RINSE AID COMPLETE
o o
V T-Mii
г^l8
Turbo
Clean
►
START
If your unit has a display window similar to the one shown
above, follow the instructions below.
CANCELING A CYCLE
• Hold down the CANCEL button until the display shows
“
0
:
01
”. Wait for the end of cycle indicator.
• Press “POWER” button to turn the unit off. Then press
the “POWER” button again to turn the unit back on.
• One of the cycle LEDs will flash. This indicates that the
unit has been reset.
CHANGING A CYCLE
If you need to change the running cycle to a new cycle:
• Hold down the CANCEL button until the display shows
“
0
:
01
”
• Press POWER button to turn the unit off. Then press the
“POWER” button again to turn the unit back on
• You can now select a new cycle.
Control Lock
• After pressing the “START” button you can activate the
Control Lock feature.
• Press and hold down the “CHINA GENTLE” button until
“CL” appears in the display window. Now any button
you press (except POWER) will not function and “CL”
will display each time.
• To deactivate, press and hold the “CHINA GENTLE”
button until the “CL” disappears from the display
window.
To enter the options mode:
(rinse aid setting, dry assist)
• Door must be closed. Press the “POWER” button to turn
the unit on.
• The countdown display and one of the Wash Cycle LEDs
will be flashing.
• Press and hold the “NORMAL WASH” button, then
press and release the “START” button. Now release the
“NORMAL WASH” button.
• The display will show either “d:00 - d:01 ” or
“r:00 - r :06”. You are now in the options setup mode.
• Press “NORMAL WASH” to select the option you would
like to adjust.
If the display shows “d:00” or “d:01” you can turn the Dry
Assist ON or OFF.
If the display shows between “r:00” to “r:06” you can adjust
the amount of rinse agent dispensed.
To set the amount of Rinse Aid:
NOTE: If your glasses have spots on them, you need more
rinse agent. If your glasses have streaks, you need less
Rinse Agent.
Follow the instructions to enter "options" mode. With the
display showing between "r:00" - "r: 06 ":
• Press the or “+” button to change the amount of
rinse agent dispensed.
r:00 Rinse Agent OFF
r:03 Medium amount of rinse agent dispensed
r:06 Highest amount of rinse agent
• Press “START” to save.
Dry Assist
With this option you can raise the temperature of the
rinse water and increase the drying time for improved
drying.
Follow the instructions to enter “options” mode. With the
display showing “d:00” or “d:01”:
• Press the or “+” button to activate or deactivate dry
assist.
d:00 Dry Assist OFF
d:01 Dry Assist ON
• Press “START” to save.
Delay Start
This option allows you to delay the start time of your cycle.
To select this feature:
• First select the desired cycle.
• Then press the or “+” button until you see the
desired delay time.
• The cycle will start once the displayed time elapses.
A WARNING
You could be seriously scalded if you allow hot water
to splash out of the dishwasher. OPEN THE DOOR
CAREFULLY during any wash or rinse cycle. Do not fully
open the door until water noises have stopped.
1 5