Rinse agent – Kenmore 630.1391 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RINSE AGENT
Rinse Agent
To achieve proper drying, always use a liquid rinse agent,
even if your detergent contains a rinse agent or drying
additive.
NOTE: The Rinse Agent LED that illuminates when the Rinse
Agent is low.
The LED will not illuminate if there is enough rinse agent in
the dishwasher.
Filling the dispenser
•
Make sure the dishwasher door is completely open.
•
Add liquid rinse agent to the dispenser as shown below
until the rinse agent reservoir is full.
Wipe up any excess rinse agent that puddles when the
dispenser reservoir is full to prevent oversudsing.
After filling the rinse agent dispenser, the indicator light will
go out in a few minutes after the dishwasher door is shut
(select models only).
Lift tab to
open
Always use Rinse Agent even if your detergent contains
rinse agent.
Add rinse agent when the Rinse Agent Indicator Light
on the control panel illuminates.
1 2