beautypg.com

Check/clean the stainless steel inner door and tub, Check/clean the filter system, Clean the exterior door panel – Kenmore 630.1730 User Manual

Page 14: Clean the door gasket, Care and maintenance-continued, Maintenance tasks 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Care and Maintenance-continued

4. Check/Clean the Stainless Steel Inner Door and Tub

a) Clean the outer edges of the inside door panel regularly to

remove debris that might coliect there from normal loading.

£>) If spots begin to appear on the stainless steel tub or inner

door, make sure the rinse agent reservoir is full.

5. Check/Clean the Filter System

Your dishw/asher has a filter system that is made up of a Large

Object Trap/Cylinder Filter assembly and a Fine Filter. The filter

system is located on the dishv\/asher floor and is easily

accessible.

During normal use the filter system Is self-cleaning, but you

should occasionally inspect it for foreign objects and clean It

when necessary.

To Remove the Large Object Trap/Cylinder Filter Assembly:

a) Remove the bottom rack.

jfj) Grasp the assembly as shown In Figure 31, and turn it

counter-clockwise 1/4" turn.

c)

Lift out the assembly as shown in Figure 32.

A

CAUTION

INJURY HAZARD: The large object trap could contain

sharp objects. Do not reach into the large object trap
with your fingers.

cf) Carefully examine the assembly. If you find debris in the

Large Object Trap, turn it upside-down and gently tap it on a

surface such as a countertop to dislodge and remove the

debris. Flush the Cylinder Filter clean by holding it under

running water.

To Remove the Fine Filter and the Micro Filter:

e)

Lift the Fine Filter from the dishwasher floor as shown in

Figure 33 and flush it clean by holding it under running water.

To reinstall the filter system:

f) Return the Fine Filter to its installed position

g)

Place the Large Object Trap/Fine Filter Assembly into its

installed position in the dishwasher floor.

h) Turn the ring handle clockwise 1/4 turn until it is locked. The

arrow on the ring handle and the arrow on the Fine Filter

should point to each other, as shown by the circle in Figure

34.

i)

Gently pull the ring handle to ensure that the Assembly is

locked into place.

6. Clean the Exterior Door Panel

CAUTION

POSSIBLE DISHWASHER DAMAGE: Your dishwasher’s
exterior door panel can be damaged If you try to clean it
with harsh chemicals, abrasive cleaners, scouring pads
(metal or plastic), or abrasive cioths/paper towels. Do not
use harsh chemicals, abrasive cleaners, scouring pads
(metal or plastic), or abrasive cioths/paper towels to clean
your dishwasher’s exterior door panel.

Colored Exterior Doors

a) Use only a soft cloth that is lightly dampened with soapy

water.

Stainless Steel Exterior Doors

a) Use a soft cloth with a non-abrasive cleaner made for

cleaning stainless steel. For the best results, apply the

stainless steel cleaner to the cloth, then wipe the surface.

7. Clean the Door Gasket

a) Regularly clean the door gasket with a damp cloth to remove

food particles and other debris.

Maintenance Tasks

13

This manual is related to the following products: