Kenmore 630.1730 - Manual (Page 11)

Using your Dishwasher..continueci
3. “Refill Rinse Aid” indicator
Fill the Rinse Aid dispenser when the Refill Rinse Aid message
comes on as shown in Figure 23.
4. “Sanitized” Indicator
The Sanitized indicator appears on the control pane! dispiay as
shown in Figure 24.
A WARNING
SCALD HAZARD: You could be seriously scalded if you
open the dishwasher door quickly during a wash or rinse
cycle. Do not fully open the dishwasher door for at least
10 seconds after the dishwasher has stopped, or until
water noises stop.
b) Wait at least ten seconds or until water noises stop before
opening the dishwasher door.
c) To resume the cycle, shut the dishwasher door and press
the On/Off button.
6. Canceling or Changing a Cycle
a) To cancel or change a cycle, press and hold for three
seconds the two buttons labeled “Cancel Drain" as shown in
Figure 25 until the digital readout shows “0".
When the Sanitized indicator lights, it means that your dishes
have been sanitized according to very strict standards of wash
time and water temperature. The standards for sanitization are
set by the National Sanitation Foundation (NSF) and are
explained in the document ANSI/NSF 184, Residential
Dishwashers. More information on NSF standards is available
at the NSF website httpV/www.nsfconsumer.org/home/
appliances.asp.
The dishwasher cycles that are NSF certified are Scrub Wash,
Normal Wash, and China Gentle. When these cycles are
complete, the “Sanitized" indicator on your dishwasher control
panel will illuminate.
Note: If your household water supply is too hot, your
dishwasher’s heating time may be reduced and the “Sanitized"
light or symbol may not illuminate. Your dishwasher installation
Manual has information on the recommended temperature for
your household hot water supply.
5. Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to add or remove an
Item, to add detergent, etc.), it is best to do so within the first 30
minutes of the cycle.
a) Press the On/Off button to stop the dishwasher.
b) Walt for approximately one minute, then press the On/Off
button
c) You may now begin a new cycle.
E. Wash Cycle Options
1. Top Пег Only™ Cycle
This option allows you to save energy and water by washing
loads small enough to fill only the top rack.
Note: The Top Tier Only option does not reduce wash time.
To use the Top Tier Only cycle
a) Load the top rack.
b) Press the On/Off button.
c) Press the button for the desired wash cycle.
d) Press the Top Only button.
2. Delay Start
This option allows you to delay the start of the selected wash
cycle for up to 24 hours.
a) Press the On/Off Button
b) Press and hold for three seconds the Delay Start button as
shown in Figure 26 until the LED display shows the number
of hours of delay desired.
c) Press the button for the desired wash cycle. You can change
the delay time and/or the cycle at any time during the delay.
10
Adding Detergent and Rinse Aid Operating the Dishwasher