beautypg.com

Oven vent location, Removing, replacing and arranging oven racks, Air circulation in the oven – Kenmore ELITE 790. 7830 User Manual

Page 8: Before setting oven controls

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Before Setting Oven Controls

Oven vent location

The oven vent is centered just below the control panel as

shown in Fig. 1. When the oven is on, warm air passes

through this vent. This venting is necessary for proper air

circulation in the oven and good baking results. Do not

block oven vent.

oven vent

Types of oven racks

Removing, replacing and arranging oven racks

A

CAUTION

I Always use pot holders or oven mitts when

using the oven. When cooking, the oven interior and

exterior, oven racks and cooktop will become very hot

which can cause burns.

A WARNING

Protective Liners — DO NOT USE

ALUMINUM FOIL to line the oven bottom. Only use

aluminum foil as recommended in this manual. Improper

installation of these liners may result in risk of electric

shock, or fire.

Arranging

-

always

arrange

the oven racks when the oven

is cool (prior to operating the

oven).

To remove - pull the rack

forward until it stops. Lift up

front of rack and slide out.

To replace - fit oven rack

onto the rack guides on both

sides of oven walls. Tilt the

front of oven rack upward

and slide the rack back into

place. Be sure oven racks are

level before using.

o

o

o

o

e

o

Fig. 2

Recommended oven rack positions by food type

(Refer to Fig. 2)

Food type

Position

Broiling

See broil

Cookies, cakes, pies, biscuits & muffins

3 or 4

Frozen pies, angel food cake, yeast, bread

and casseroles

2 or 3

Small cuts of meat or poultry

1 or 2

Turkey, roast or ham

1 or 2

flat

oven rack

flat

handle

oven rack

offset

oven rack

The flat oven rack (some models) or flat handle oven rack

(some models) may be used for most cooking needs.

The offset oven rack (some models) is designed to place

the base of the rack about 1/2 of a rack position lower

than flat oven racks. This design provides several additional

possible positions between the flat rack positions.

Air circulation in the oven

For best baking results allow 2-4" (5-10 cm) around the

cookware for proper air circulation and be sure pans and

cookware do not touch each other, the oven door, sides or

back of the oven cavity. Hot air must be able to circulate

around the cookware in the oven for even heat to reach

around the food (See Fig. 3 ).