Kenmore 2318589 - Manual (Page 11)

The set point range for the freezer is -
-15°C) and 33°F to 41°F (r C to 5°C)
5°F to5°F (-2rC to
for the refrigerator.
CONDITION: TEMPERATURE
ADJUSTMENT:
REFRIGERATOR too cold
- Not set correctly for your condifions
REFRIGERATOR
Control 1 ° higher
REFRIGERATOR too warm
- High use or room very warm
REFRIGERATOR
Control 1 ° lower
FREEZER too cold
- Not set correctly for your conditions
FREEZER Control
1° higher
FREEZER too warm/too little ice
- High use or heavy ice use
FREEZER Control
1 ° lower
Accelerated Ice Production
The Accelerated Ice feature assists with temporary periods of
heavy ice usage by increasing ice production over a 24-hour
period.
■ Press the ACCELERICE'^ touch pad to set the freezer
temperature to -10°F (-23°C). The Accelerated Ice setting will
remain on for 24 hours unless manually turned off. The
display will continue to show your normal temperature set
point.
■ If increased ice production is desired at all times, set the
Freezer Control to a colder setting. Adjusting the freezer to a
colder temperature may make some foods, such as ice
cream, harder.
SmartSense^“ Temperature Management
The SmartSense^“ feature assists with regulating the
temperature inside the refrigerator. If a large quantity of warm
food is placed in the refrigerator or warm air enters the
refrigerator while the door is held open, SmartSense^'*' activates
to quickly restore the temperature to the set point.
s m a r t : . -
NOTE: SmartSense"^'^ is always on when your refrigerator is
operating. You do not need to press any buttons to activate it.
The LED light on the control panel indicates that the feature is
functioning properly.
Control Lockout
Control Lockout disables the control touch pads to allow easy
cleaning and prevent unintentional control setting changes.
To disable the controls, press and hold the LOCK button for
2 seconds.
■ To reactivate the controls, press and hold the LOCK button
for 2 seconds again.
NOTE: The lockout feature does not shut off power to the
refrigerator or freezer. It simply deactivates the control panel
buttons. The digital control panel display will remain lit and the
buttons will beep when pressed, but no settings will be changed.
Door ^ar Alarm
The Door Ajar Alarm feature sounds an alarm when the
refrigerator or freezer door is open for 5 minutes. The alarm will
repeat each minute until both doors are closed or Door Ajar
Alarm is silenced or temporarily turned off.
When a door is opened, the Door Ajar Alarm feature is activated
and the indicator lights up. The indicator light blinks when the
alarm sounds.
NOTE: The Door Ajar Alarm feature turns off when both doors
have been closed. It resets and will re-activate when either door
is opened again.
i*'5T\
iDoorAjaiy
If alarm has not yet sounded and indicator iight is on:
■ Press DOOR AJAR to temporarily turn the feature off. Press
the button a second time to re-activate the feature.
If alarm is sounding and indicator light is blinking:
■ Press DOOR AJAR to silence the alarm. The indicator will
stop blinking and remain on. If the door remains open for
another 5 minutes, the alarm will sound again.
■ To temporarily turn the feature off, press DOOR AJAR a
second time before 5 minutes have passed. Once it is off.
Door Ajar Alarm can be re-activated at any time by pressing
DOOR AJAR again.
Depending on your model, your water and ice dispensers may
have one or more of the following features: a rotating water
dispenser faucet and pull-out tray, a special light that turns on
when you use the dispenser, a lock option to avoid unintentional
dispensing, or an indicator that tells you when there has been a
power outage.
NOTES:
■ The dispensing system will not operate when the freezer door
is open.
■ After connecting the refrigerator to a water source, flush the
water system by dispensing water into a sturdy container
until you draw and discard 1.5 gal. (5.4 L) of water, or for
approximately 3 minutes after the water begins dispensing.
The flushing process cleans the water system and clears air
from the lines. As the air is cleared from the lines, water may
spurt out of the dispenser.
■ Allow 24 hours for the refrigerator to cool down and chill
water.
■ Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
11