Kenmore POWER MISER 153.320661 - Manual (Page 9)

A WARNING
Fire Hazard / Electric Shock Hazard
è
• Do not use this water heater with
any voltage otherthan shown on the
model rating plate.
• Failure to use the correct voltage
shown on the model rating plate
could result in death, serious bodily
injury, or property damage.
Before making the conversion to 5500 watts, check the (1)
power suppiy , . . must be 240 volts, (2) wiring . . . 10 gauge
AWG @ Type TW, 60°C or equivalent, and (3) Circuit breakers
or fusing . . .capabie of 30 amp loading. Also, the installation
must conform with this manual, local codes and electric utility
rules. Failure to comply can result in DEATH, SERIOUS BODILY
INJURY OR PROPERTY DAMAGE.
ELECTRIC
WATER HEATER
MODEL NUMBER
CAPACITY
U.S. GAL.
LISTED
9$2M
SERIAL NU[\iBER
FACTORY EQUIPPED WITH
UPPER LOWER
ELEMENT ELEMENT MAXIMUM VOLTS
WATTS WATTS WATTS A.C. ONLY
MAXIMUM
CHECK HERE WORKING
IF INSTALLED AS PRESSURE
FACTORY EQUIPPED P.S.I.
OPTIONAL WATTAGE
UPPER LOWER
ELEMENT ELEMENT MAXIMUM
WATTS WATTS WATTS
CHECK HERE
IF CONVERTED
WARNING
SEE CONVERSION
INSTRUCTION
NOTE: Whether or not the element conversion is made the
model rating plate must be marked. Using a hard point ink
pen, check the appropriate block within the model rating plate,
which is located adjacent to
the lower access panel.
Water Piping
ADANGER Water temperature over 125“F
(52°C) can cause severe burns
instantly resulting in severe injury
or death.
Children, the elderly, and the
physically or mentally disabled
are at highest riskfor scald injury.
Feel water before bathing or
showering.
Temperature limiting valves are
available.
Read instruction manual for safe
temperature setting.
HOTTER WATER CAN SCALD; Wafer heaters are intended to
produce hot water. Water heated to a temperature which will
satisfy clothes washing, dish washing, and other sanitizing
needs can scald and permanently injure you upon contact.
Some people are more likely to be permanently injured by hot
water than others. These include the elderly, children, the infirm,
or physically/mentally handicapped. If anyone using hot wafer
in your home fits info one of these groups or If there is a local
code or state law requiring a certain temperature water at the
hot water tap, then you must take special precautions. In
addition to using the lowest possible temperature setting that
satisfies your
hot water needs, a means such as a mixing
valve, shall be used at the hot wafer taps used by these people
or at the water heater. Mixing valves are available at plumbing
supply or hardware stores. Follow manufacturers instructions
for installation of the valves. Before changing the factory setting
on the thermostat, read the “Temperature Regulation” section
in this manual.
FIGURES.
Figure 9 shows the attachment of the water piping to the water
heater. The water heater is equipped with 3/4” water
connections.
If a water heater is installed in a closed wafer supply system;
such as one having a back-flow preventer, check valve, wafer
meter with a check valve, etc... in the cold water supply; means
must
be provided to control thermal expansion. Contact the
local utility or Sears Service Center on how to control this
situation.
NOTE: ¡f using copper tubing, solder tubing to an adapter
before attaching the adapter to the water inlet connection.
Do not solder the water supply lines directly to the cold water
inlet, it will harm the dip tube and damage the tank.
CAUTIO I
Property Damage Hazard
> Avoid water heater damage.
' Install thermal expansion tank if necessary.
• Do not apply heat to cold water inlet.
■ Contact qualified installer orsen/ice agency.