Kenmore POWER MISER 153.320661 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Note: To check where threaded portion enters tank, insert
cotton swab between jacket opening and fitting. If cotton is
wet, follow “Draining” instructions in the “Service and
Maintenance”section and then remove fitting. Put pipe dope
or teflon tape on the threads and replace. Then follow “Filling
the
Water
Heater"
instructions
in
the
“Installation
Instructions” section.
FIGURE 46.
26
This manual is related to the following products: