B. unpacking the water softener, B. unpacking the water softener -2, Before installing checks & tests – Kenmore Water System User Manual

Page 5: 2 deluxe valve

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

j j

SECTION 1

:^.

:^.^

' '

BEFORE INSTALLING CHECKS & TESTS

B. UNPACKING THE WATER SOFTENER

Directions for unpacking the softener are on the top
of the shipping carton. This manual, and the own
er's manual, were in the small parts bag. You will
need the small parts to install the softener. Keep
them in the bag until you are ready to use them so

you don't lose any parts. Remove all other card
board pieces, foam packings, tapes, etc. from the

softener and discard.
Check the softener for shipping damage. If you
find damage, report it to your Sears store.

Use care when handling the softener. DO NOT turn
upside-down. DO NOT drop, or set on sharp objects
that could make a hole in the bottom. The water soft
ener is heavy and to avoid damage, or personal inju
ry, do not try to lift it or move more than necessary.

See page 3-4, when you are ready to move it into

installation position.

FIG. 1

PARTS DESCRIPTIONS

SMALL PARTS

FACE

PLATE

in<;

installation manual

owner’s manual

bypass valve

(included with some models)

copper

tubes (2)

gaskets (2)

installation

nut (2)

tube

clamp (2)

drain hose

ground clamp kit

tube

adaptor

grommet

1-2 Deluxe Valve

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line