D. connect valve and salt tank drains, Step by step guides to install – Kenmore Water System User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Ls j

:^.

j j

:^.

j j

:^.

SECTION 3

STEP BY STEP GUIDES TO INSTALL

D. CONNECT VALVE AND SALT TANK DRAINS

CONNECT SALT TANK OVERFLOW TU

BING

Take the rubber grommet, tube adaptor and

tube damp (FIG. 12) that are in the parts bag.

o Push the grommet into the hole in the salt tank

wall so half is inside and half is outside.

e Push the bigger end of the tube adaptor into the

grommet.

Push one end of a length of 3 / 8'T.D. tubing onto
the tube adaptor, using the tube clamp to hold

it in place. Put the other end of the tubing over

the floor drain.

Important:

• The salt tank overflow is for safety only. If the

salt tank should overfill with water, the over

flow tubing carries it to the drain.

•

Over-flu water must run downward through

the tubing. Do not raise the tubing higher than
the grommet and tube adaptor (FIG. 12).

•

Do not connect to the valve drain hose you

installed in step 1. Both drains must have a sepa
rate hose or tube.

3-6 Deluxe Valve

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line