Kenmore ELITE 795.7105 - Manual (Page 43)

TROUBLESHOOTING GUIDE
NOT DISPENSING ICE
Check if... Then...
All the doors are not closed completely. Ice will not dispense if any of the refrigerator doors are left
open.
The dispenser display is locked. Press and hold the Lock ( ) for 3 seconds to unlock the
control panel and dispenser.
Ice is not selected on the dispenser. The dispenser can be set for ice or water. Make certain that
the control panel is set for the proper operation. Press the
dispenser button on the control panel to cycle through the ice
and water options.
The ice dispenser is not used often. Infrequent use of the ice dispenser will cause the cubes to
stick together over time, which will prevent them from properly
dispensing. Check the ice bin for ice cubes clumping/sticking
together. If they are, break up the ice cubes to allow for proper
operation.
Ice bin is not installed correctly. Be sure to install the ice bin firmly into position.
New installation. Wait 24 hours after ice maker installation for ice production to
begin. Wait 72 hours for full ice production.
Ice cubes are stuck in the delivery chute. Use a plastic utensil to clear the delivery chute.
The ice dispenser is stalling while dispensing
“crushed” ice.
Change the ice button from “crushed” to “cubed”.
If cubed ice dispenses correctly, depress the button for
“crushed” ice and begin dispensing again.
DISPENSING WARM WATER
Check if... Then...
New installation. Allow 24 hours after installation for the water supply to cool
completely.
The water dispenser has been recently used. The unit has its own water tank inside. The water storage
capacity is 12 oz. (345 ml) of cold water.
The refrigerator is connected to a hot water line. Make sure the refrigerator is connected to a cold water pipe.
43