Filter, Remove the old filter, Replace with a new filter – Kenmore ELITE 795.7105 User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

FILTER

It is recommended that you replace the filter

approximately every 6 months
when the water filter indicator
( @ ) turns on, or when the
ice and water dispenser
noticeably decreases output.

1. Remove the old filter.

• Press the push button to

open the filter cover.

NOTE: Replacing the filter

causes a small amount of
water (around 1 oz. or
25 cc) to drain. Place a cup

under the filter hole to catch
any waste.

Pull the filter downward

and pull out.

Replace with a new filter.

• Take the new filter out of it's packaging and

remove the protective cover from the o-rings.

With filter "tabs" in the horizontal position, push
the new filter into the manifold hole until it stops.

' Firmly lock in the filter.

The cover will click back into

place.

3. After replacing the filter, flush 2.5 gallons through

filter before use (flush for approximately
5 minutes) and check the filter for leaks.
To reset the water filter status display and

indicator light, press and hold the Ultra Ice (Filter
Reset) button for at least 3 seconds.

4. Filter Bypass Plug

Keep the filter bypass plug.

You MUST use the filter bypass

plug when a replacement filter

cartridge is not available.

CAUTION: DO NOT operate

refrigerator without filter or

filter plug installed.

NOTE: To purchase replacement water filter, visit

your Sears store or 1-800-4MY- HOME. Also
visit us on the web at

WWW.

se ars.

m/partsd i rect.