Kenmore 665.1703 - Manual (Page 10)

Standard adjustable 2-position top rack
(on some models)
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate items up to
9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate items up to 11" (28 cm) in
both the top and bottom racks. Two adjusters are located on
each side of the top rack. Each adjuster has 2 preset positions.
The high and low positions are marked on the adjuster.
To adjust the top rack
1. Hold the top rack with one hand near the adjuster.
Flexible tines (on some models)
2. With the other hand, pull out the top of the adjuster.
3. Raise or lower the rack to one of the preset positions.
4. Release the adjuster.
5. Repeat the steps for the remaining adjusters.
NOTE: The top rack must be level.
Removable top rack
The removable top rack allows you to wash larger items
such as stock pots, roasters, and cookie sheets in the bottom
rack.
IMPORTANT: Remove dishes prior to removing the rack from the
dishwasher.
To remove the top rack
1. Pull the rack forward slightly to access clips.
2. While pressing the ridges in, push back on the clip until the
outer side releases. Slide the clip to the inside of the track
edge to remove the clip.
3. After removing both clips, pull rack out.
To replace the top rack
1. Place the rollers on each side of the rack into the rack tracks
and push the rack back.
2. Align the open side of the clip with the inside edge of the rack
track.
3. Push the ridges and slide the clip toward the outside rack
edge until it locks into place.
4. Repeat on the other side.
5. Pull the rack out all of the way to ensure clips are fully seated.
The row of tines on the left-hand and right-hand sides of the top
rack can be adjusted to make room for a variety of dishes.
To adjust the flexible tines
1. Grasp the tip of the tine that is in the tine holder.
2. Gently push the tine out of the holder.
3. Lay the tines down, toward the center of the rack.
No-flip clips (on some models)
The no-flip clips hold lightweight plastic items such as cups, lids,
or bowls in place during washing.
To move a clip
1. Pull the clip up and off the tine.
2. Reposition the clip on another tine.
The bottom rack is designed for plates, pans, casseroles, and
utensils. Many items, up to 13" (33 cm) tall, fit in the bottom rack.
(See recommended loading patterns shown.)
NOTE: The features on your dishwasher rack may vary from the
drawings shown.
10 place setting
Do not load glasses, cups, or lightweight plastic items in the
bottom rack. Load small items in the bottom rack only if they
are secured in place.
Load plates, soup bowls, etc., between tines.
Overlap the edges of plates for large loads.
10