Kenmore 790.9659 - Manual (Page 34)

Warmer Drawer Removal
• Removing & Replacing Warmer Drawer
Pull up with finger
Push down with finger
Fig. 1
To Remove and Replace Warmer (Warm &
Ready™) Drawer
A WARNING
Electrical Shock Hazard
can occur and result in serious injury or
death. Disconnect appliance from electric
power before cleaning and servicing the
warmer drawer.
To Remove Warmer Drawer:
A caution I Turn powerOFF before removing the
warmerdrawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a
hex-head screw (See Fig. 1). Use a 1/4” socket and
ratchet to remove the shield.
4. Locate glide lever on each side of drawer, pull up on the
left glide lever and push down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis
glide (See Fig. 2).
3. Align the glide on each side of the drawer with the glide
slots on the range.
4. Push the drawer into the range until levers “click”
(approximately 2”). Pull the draweropen again to seat
bearing glides into position. If you do not hear the
levers “click” or the bearing glides do not feel
seated remove the drawer and repeat steps 2-4.
This will minimize possible damage to the bearing
glides.
NOTE: The Warmer Drawer will NOT operate while in the /
Self-Clean and “Oven Lockout” modes
; ^
Fig. 2
34