To replace belt, Belt routing – Kenmore ASPIRADORA 116.34728 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO CLEAN AGITATOR
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned accord
ing to the following schedule:
Clean Agitator
every week
Vacuum Use
HEAVY -
(used daily)
MODERATE -
every month
(used 2-3 times/week)
LIGHT -
every 2 months
(used 1 time/week)
Remove any dirt or debris in the belt path
area or in the agitator area.
TO REPLACE BELT
Make sure that the carpet/bare floor selec
tor is in the carpet position.
Loop the new belt on the motor shaft,
NOTE: See PARTS AND FEATURES for
belt number.
Loop the end of the new belt on the agitator.
Motor Carpet/Bare
Shaft Floor Selector
Shaft
Align the square extension on each end cap
with the slots in the frame of the nozzle.
NOTE: Care must be taken due to the belt
tension during reassembly.
BELT ROUTING
Correct Routing of Belt
(Selector In CaipetPosIVonj
___
I Belt '
¡CarpetIBare
' flowPedal
AgltatSr-^ ^ ^
Carpet/Bare Floor Shaft
Seleetor Shaft
Incorrect Routing of Belt
(Belton Seleetor Shaf^
.-j—Carpet/Bare
Floor Pedal
Agitator
/ Uotor
Carpet/Bere Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Selector In Bare Floor Poslthn)
Agitator
Motor Shaft
t
Belt
Carpet/Bare
FloorPedal
Carpet/Bare Floor
Selector Shaft
Press firmly, checking to see that each end
is completely inserted.
BeH
Agitator Assembly
Check to see that the belt is centered in the
belt groove. Turn the agitator with your fin
gers to see that it turns freely.
18