beautypg.com

Warning, Primary filter, Exhaust filter – Kenmore ASPIRADORA 116.34728 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

] " y ‘ I iit i I ^ i i “' ■* -1*

A

WARNING

Electrical Shock Hazard

Unplug power cord from electrical
outlet. Do not operate the vacuum
cleaner without the primary or
exhaust filters. Be sure the filters
are properly installed to prevent

motor failure and/or electrical shock.

PRIMARY FILTER

Check primary filter frequently and clean

when dirty.

TO REMOVE PRIMARY FILTER

Remove the dust bin and dust bin lid
assembly as outlined in the DUST BIN

CLEANING section.

C/esning Cam

Slot

Filter

/

\ Locking Tab

Fitter Cover

While holding

primary filter

over a trash con­
tainer grasp filter,

rotate and lift off.

Clean primary fil­

ter by gently tap­

ping over a trash
container. Tap on several sides to ensure
best cleaning. Rinse with water only as
needed, do not use any detergent or soap.

Allow the filter to dry for 24 hours before

putting it back into the vacuum cleaner.

When cleaning the filter no longer restores
vacuum suction to full power you need to

replace the filter.

Note: See PARTS AND FEATURES

for the filter number.

Cleaning Cam

Slot

TO REPLACE PRIMARY FILTER

With slot side on
filter towards the
filter cover slide

cleaning cam
inside opening,

rotate filter clock­

wise until slots lock
onto tabs in cover.

\ Locking Tab

Filter Cover

Note: Under norma) use and care, your fil­

ter can be expected to last up to 5 years.

Re-assemble dust bin lid to dust bin. Insert
into vacuum cleaner and secure with dust
bin latch.

EXHAUST FILTER

HEPA

The exhaust filter must be replaced when
dirty. It should be replaced regularly
depending on use conditions.

The filter CANNOT be washed as it will

lose its dust trapping ability.

Note: See PARTS AND FEATURES for

the filter number.

Remove filter cover by pulling out at the top

of the exhaust filter cover.

Remove the exhaust filter cartridge.

Exhaust
Filter Seal

Exhaust
Filter -

Push only on filter cartridge frame, not on

filter material itself. The foam seal of the
filter should be placed against the vacu­

um cleaner body

Replace the exhaust filter cover by placing
bottom tabs in slots and pushing in until

cover snaps into place.

16

This manual is related to the following products: