Program the timer, Fig. 24, Fig. 25 – Kenmore 625.38306 User Manual

Page 66: Set present time of day, Program the timer -19, U' i. i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Program The Timer

Display

UP Button

;V\,

3G0 Seríes

FIG. 24

PROGRAM THE TIMER

1. When the transformer is plugged in, a model code

(S 25) and a test number (example: J1.1) show in the

face plate. This will display for four (4) seconds. Then,

12:00 PM and the words

SET TIME

begin to flash.

NOTE: If “----------” shows in the display, press the

UP or DOWN button until S 25 shows in the dis

play. Then, press the SELECT button to set, and

change to the flashing SET TIME display.

To check the model code, unplug the transformer at

the wall outlet and plug in again.

If other than S 25

shows, refer to the Troubleshooting Section.

SOUND “BEEPER”:

A “beeper” sounds while press

ing buttons for timer setup. One beep signals a
change in the face plate display. Repeated beeps
mean the timer will not accept a change from the but

ton you have pressed, telling you to use another but
ton. For example, while setting the hardness, the

beeper sounds repeatedly when the display reaches 1
using the DOWN button, or the highest hardness set

ting using the UP button.

u' I. I

SET

TIME

lг

:[¡0

FIG. 25

SET PRESENT TIME OF DAY

If the words

SET TIME

do not show in the display, press

the SELECT button until they do show in the display.

Press the UP or DOWN buttons to set the present time.
Press UP to move the display ahead; press DOWN to
move the time backward. If the present time is between
noon and midnight, be sure PM shows. If the present

time is between midnight and noon, be sure AM shows.

Each press of the UP or DOWN buttons changes the

time by one (1) minute. Holding the buttons in changes
the time 32 minutes each second.

FIG. 26

Questions? Call The Kenmore Water Line 1-800-426-9345