4G Systems XSJack T3e - Manual (Page 10)

10
Entering service codes
Your XSJackT3 is operated and configured using special sequences of
digits you have to enter to the keypad of your connected telephone or
fax machine (0 - 9, *, #).
Fax machines without telephone receiver sometimes feature a dedica-
ted button to go offhook and onhook, which may be indicated by an
icon like a telephone receiver or loudspeaker. Refer to the manual of
your fax machine for additional information.
On devices with telephone receiver or dedicated offhook/onhook
button, proceed as follows:
■ Lift the telephone receiver or press the corresponding button on
your fax machine.
■ Wait for a continuous dial tone audible in the telephone receiver
or from the loudspeaker of the fax machine.
■ Enter the sequence as specified by the format described in the
corresponding tables within this manual. Replace placeholders
written in capital letters inside the format specifications by the
desired numerical values.
■ Wait for a positive or negative command response tone. Some
service codes are provided to query information about specific
settings from the XSJackT3. These codes will answer using the
'Enabled' or 'Disabled' response codes and some will additio-
nally show you numerical values on the display of your phone
via CLIP after going back onhook.
■ Put down the telephone receiver again or press the correspon-
ding button on your fax machine.
Note: Refer to page 24 for an overview of all possible dial tones and
response tones.