GE 2-9730 - Manual (Page 18)

In case of difficulty, check the following before seeking service.
Donm 17ЯЛ
cm 1 1 ТШЫ
No Dja| Tonr? 1, Check Installation;
— Is BASE POWER CORD connected to a working outlet?
tf.
^UAn/iiMr: I inuT
uyiA/nccm
1^ w#
— Do not use an outlet that can be turned ON and OFF by a wall
switch. '
— Is TELEPHONE LINE CORD connected firmly to the base unit
and phone outlet?
— Is BASE ANTENNA raised?
2. Is CORDLESS HANDSET out of range of the base?
3. Make sure SATTERiES are properly charged (12 Hours).
4. Is the BATTERY PACK installed correctly (see page 11)?
5. Did the CORDLESS HANDSET beep when you pressed the phone
Kl iff ArtO пК/ЧПА llAKf AAfVSrt AnO If nAt %Г/Ч< 1 Г
L/U 4 VWII: u/iu uiv piivri^ v/s/nic; k,#} i: ii 4 1 4 ^ 1 , yv/ui may
need to be charged.
6. Disconnect CORDLESS PHONE and connect another phone to the
same jack. If no dial tone, then the problem may be in your wiring
or local service.
7 VA/hanoi/ar ^ r\rku/ar Aiifana r\r Kattoriae ara tbA
« . Vf*l9ll^vei a ^WTWI S/V 4,/Ui.L^I VI 1^
HANDSET must be returned to the BASE to reset Security Code
Dial Tone but can’t
uiai uui
8. If you have pulse service on your line, your TONE/PULSE Switch on
....... .....................U>4 AM Ulo оаэс mudi uv vii
Hsndset d06S not
ring 9 . M 3|{9 sur8 R!NGEH Switch on H3.nds8t Is “ON”.
1 0 . Do you have too many extension phones on your telephone line? Try
unplugging some other phones.
11. Perform checks 1.2.3.4.5.6 and 7 above.
You experience
static, noise, or fading
12. Is BASE ANTENNA raised?
13. Is HANDSET out of range from the BASE7 Move closer to BASE.
14. Does the BASE need to be relocated?
15. Is CORDLESS BASE plugged into an outlet with household
appliances? If so move the appliance or telephone.
1fi P.hRnlf in«!tiillatinn ner 1 shnve fSfin 7 abovel
Unit beeos. 17. Charge BATTERY for 12 hours.
18. Clean charging contacts on HANDSET and CRADLE with a soft cloth.
19. Check installation per 1 above.
20. Replace BATTERY.
Memory Dialing
Problems
21. Did you program the memory correctly (see page 15)?
22. Did you follow proper dialing sequence (see page 12)?
23. See 8 above.
24. Did you reprogram numbers into memory after power outage or
replacing Battery? (See Page 17)