Flooring under the range, Leveling the rai^e, Self-cleaeing oven – GE 49-4992 User Manual

Page 5: If ¥>u need service

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

® Make sure broiler pan is in
place

correctly

reduce the

ossibiliiy of grease fires.

If yoa should have a grease

lire 111 the broiler pan, turn off

oven, and keep oven door closed
to contain fire until it burns out.

Self-CleaEing Oven

» Do not dean the door gasket

before reading special cleariliig
Inslrectloiîs Olì page 20. The

door gasket is essential for a good

seal Be careftil not to rub, damage

or move it.

® Do not use oven cleaners. No

commercial oven cleaner or oven

liner protective coating of any
kind should be used in or around

any part of the oven.

® Remove the broiler pan

and

other cookware before self-

^^-îenning the oven.

^£1еап1пд

Your

Mange

Clean only parts listed in this

Use and Care Book.

® Keep range dean and free

of acciimnlatlons of grease or

spilloveins which may Ignite.

If ¥>u Need Service

® Read “The Problem Solver’’

OÏI page 26 of this book.

® Don’t attempt

repair

or replace any part of your
range unless it Is specifically
recommended in this book. All

other servicing should be referred

to a qualified technician.

Flooring under the

Range

Vbur range, like so many other
household items. Is heavy and can

seltle into soft floor coverings

such as cushioned vinyl or

carpeting. When moving the range
on this type of flooring, use care.

Do not install the range over
kitchen carpeting unless you
place an insulating pad or sheet of

1/4-inch-thick plywood between

the range and carpeting.

When the floor covering ends at the

front of the range, the area that the

range will rest on should be built up
with plywood or similar material to
the same level or higher than the
floor covering. This will allow the

range to be moved for cleaning or
servicing.

Leveling the Rai^e

Leveling legs are located on each
corner of the base of the range.
Remove the bottom drawer and you

can level the range on an uneven floor.

To remove drawer, pull drawer
out all the way, tilt up the front
and take it out. To replace drawer,

insert glides at back of drawer
beyond stop on range glides.
Lift drawer if necessary to insert
easily. Let front of drawer down,
then push in to close.

One of the rear leveling legs

will engage the ANTI-TIP bracket
(allow for some side to side
adjustment). Allow a minimum
clearance of 1/8" between the range
and the leveling leg that is to be
installed into the ANTI-TIP bracket.

;:-:-:-

.............

■ ......