GE Feb-50 - Manual (Page 14)

6
.
Troubleshooting Chart
PROBLEM
SOLUTION
LED’s do not light.
Is AC power supply plugged into an electrical
outlet and the telephone.
Telephone does not
operate during power
outages.
Is a good 9 volt battery installed? (A 9 volt
battery will allow use of the handset during
power outages.)
Telephone functions
with the handset, but
there is no response
to any button with the
phone on hook.
Is AC power supply plugged into an electrical
outlet and the back of the telephone.
LED above intercom
button is flashing red
and green.
Intercom Station needs to be programmed.
Press Intercom station address button.
LED above Intercom
button is flashing red
and green and an error
tone sounds when any
intercom station ad­
dress button is
pressed.
Check that lines 1 and 2 are properly con­
nected to the telephone.
While programming the
Intercom Station Ad­
dress the Intercom
LED flashes red, then
the phone beeps and
the Intercom LED
starts flashing red and
green again.
The Intercom Station Address selected is
already in use by another telephone. Select
another Intercom Station Address. (The Inter­
com Station Address for a telephone can be
verified by pressing each station address but­
ton until a 3 beep tone is heard.)
When making an inter­
com call the Intercom
LED turns green, then
an error tone is heard
and the LED turns off.
Intercom Station being called is not assigned
or has been disconnected. The intercom sta­
tion address for a phone can be checked by
pressing all the station address buttons until
a 3 beep response is heard.)
Telephone does not in­
dicate status of other
2-9450 telephones and
Intercom/Page is not
functioning.
Improper line connection. Perform System
Verification in the Installation Instructions.
(Step 5)