GE AEE08AR User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GEAppliances.com
Heat Mode
Use the
Heat
mode at
Low, Med, High
or
Auto Fan
Speed
for heating. Use the
Temperature increase A
/
Decrease
T
pads to set the desired temperature
between 61°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The heater will cycle on and off to keep the
room at the set level of comfort.
Cool Mode
Use the
Cooi
mode at
Low, Med, High
or
Auto Fan
Speed
for cooling. Use the
Temperature increase A
/
Decrease
T
pads to set the desired temperature
between 61°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to a
Cool
setting or if turned from a fan setting
to a
Cool
setting, it may take approximately
3
minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal
Cooling—Select the
Cool
mode and
High
or
Med fan with a middle set temperature.
For Maximum
Cooling—Select the
Cool
mode and
High
fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select
the
Cool
mode and Low fan with a middle set temperature.
Energy Saver Mode
Controls the fan.
ON—The fan will cycle on and off with the compressor.
This results in wider variations of room temperature and
humidity. Normally used when the room is unoccupied.
NOTE:
The fan may continue to run for a short time after
the compressor cycles off.
OFF—The fan runs all the time, while the compressor
cycles on and off.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan speed
to provide air circulation and filtering without cooling.
Since fan-only settings do not provide cooling, a Set
temperature cannot be entered. The room temperature
will appear in the display.
NOTE:
Auto Fan Speed cannot be used when in the
Fan
Only
Mode.
Auto Fan Speed
Set to
Auto
fan speed for the fan speed to
automatically set to the speed needed to provide
optimum comfort settings with the set temperature.
If the room needs more cooling, the fan speed will
automatically increase. If the room needs less cooling,
the fan speed will automatically decrease.
NOTE:
Auto Fan Speed cannot be used when in the
Fan
Only
Mode.
Remote Control
■
To ensure proper operation, aim the remote control
at the signal receiver on the air conditioner.
■
Make sure nothing is between the air conditioner
and the remote control that could block the signal.
■
The remote control signal has a range of
up to 20 feet.
■
Make sure batteries are fresh and installed correctly
as indicated on the remote control.
■
Remote contains a magnet allowing it to attach to
metal surfaces.
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit
will automatically re-start in the settings last used after
the power is restored. If the Delay l-24hr feature was
set, it will resume countdown. You may need to set a
new time if desired.