Making the lp conversion (cont.), H change cooktop burner orifices, Ie change cooktop burner orifices (cont.) – GE PGP959SETSS User Manual
Page 13: Installation instructions, Making the lp conversion, Cont.)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions
MAKING THE LP CONVERSION
(CONT.)
H CHANGE COOKTOP BURNER
ORIFICES
H Remove the grates, burner caps, and burner
heads.
E Using a 7mm nut driver, remove the burner
orifices. These may be accessed through the
burner holes in the cooktop.
Inner
o
burner cap
Burner
base ■
OR
Orifice spuds located
through these openings
Tri-Ring Burner
Burner
base
Orifice spud located
through this opening
Burner
^ cap
Burner
head
Electrode
□
Retainer
Ring
NOTE: On all burners, the
orifices have a spring-loaded
retaining ring around the hex
head to hold the orifice in the
nut driver during installation
and removal. A slight amount
of force is required to push the
nut driver down over the ring.
E Locate the LP orifices attached to the regulator
along with separate LP conversion instructions.
They will have a digit for size and a letter for type
of gas, on the top or side. (IMPORTANT: Save
the orifices removed from the appliance for
future use.)
Each orifice will show a series of engraved
marks, (I, II, IV or V), located on the top.
These marks denote the location of each orifice to the
cooktop burner.
ForPGP953 Models
(Shorter)
For PGP959&CGP350 Models
13
IE CHANGE COOKTOP BURNER
ORIFICES (CONT.)
CENTER BURNER
15,000 BTU/hr Extra Large Burner (PGP953 Models)
Extended spud for center
extra large burner
Burner
Cap
Burner
Head
Extended
Spud
through this opening
x1